storage-based hydro
#11

Ok, I can see you have managed to get the process E001 working. The crucial mistake I can see in the model is that HYDS is defined as a free renewable. As such, it has no commodity balance, and therefore modeling a storage process for it would be completely meaningless.

But I did not see any indication of a supply process for HYDS; you should create such as well. I would thus suggest that you test your model after doing the following modifications:

  • Change the commodity type of HYDS from free renewable to limited renewable (this is crucial)

o        You can also remove the superfluous COM_GMAP(REG,NRG,HYDS)

  •  If you still have no supply process for HYDS, you need to create such now:

o        Output = HYDS, PCG=HYDS, no input required

o        ANNUAL level

o        Set also a reasonable upper bound ACT_BND(UP), for the annual inflow

  • I suggest to disable the second storage process (ST0002) for now, because:

o        It has no capacity bound / investment costs, and might thus have infinite storage level without any cost impact

o        Note also that it is pointless to use NCAP_AFC(ACTGRP) if you are not using NCAP_AFC(output)

Reply


Messages In This Thread
storage-based hydro - Deju - 14-10-2015, 01:07 PM
RE: storage-based hydro - Ansh_02 - 24-03-2017, 01:09 PM
RE: storage-based hydro - Antti-L - 24-03-2017, 09:28 PM
storage-based hydro - Antti-L - 15-10-2015, 04:29 AM
storage-based hydro - Deju - 15-10-2015, 12:04 PM
storage-based hydro - Antti-L - 15-10-2015, 02:21 PM
storage-based hydro - Deju - 16-10-2015, 04:18 AM
storage-based hydro - Deju - 20-10-2015, 11:58 AM
storage-based hydro - Antti-L - 21-10-2015, 05:12 AM
storage-based hydro - Deju - 21-10-2015, 05:53 AM
storage-based hydro - Antti-L - 21-10-2015, 06:21 AM
storage-based hydro - Deju - 21-10-2015, 11:41 AM
storage-based hydro - Antti-L - 21-10-2015, 01:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)