08-07-2019, 04:18 PM
Abi Afthab Wrote:Thanks a lot for detailed reply. How did you get this maximum and minimum load of this process in each season? Is this calculated by (Var_FIn/(8760*year fraction)) of the process in each time slice? Here in my case, the electricity input is the Var_FIn. I am little confused about this term ''maximum load of the process'". I am very sorry for asking this again.If the capacity is defined by the output (as it was for the electrolyser), the load of the process is the power level of the output flow. The power level of the output flow in each timeslice can be obtained by dividing the corresponding flow (VAR_FLO.L(...)) by the year fraction G_YRFR (and optionally converting it to the capacity unit). For example, for power plants the load at any given time is regularly calculated in this way, usually converted to MW. The maximum load in each season is obtained by taking the maximum (highest) value of these levels over the timeslices in the season, and the minimum is obtained by taking the minimum (smallest) value.