Modelling Partial Load Efficiency
#1
Dear all, 

I am modelling a power plant with partial load efficiency parameter. I am using the following parameter in an hourly timeslice model:
ACT_CSTSD - COLD - LO- 0.1890
ACT_CSTSD - COLD - UP - 0.1890
ACT_CSTSD  - HOT - LO - 0.0687
ACT_CSTSD - HOT - UP - 0.0687
ACT_CSTSD - WARM - LO - 0.1031
ACT_CSTSD - WARM - UP - 0.1031
ACT_EFF -  0.3000
ACT_LOSPL - FX - 0.0720
ACT_LOSPL - LO - 0.5500
ACT_LOSPL - UP - 0.8500
ACT_MAXNON - HOT -  10.0000
ACT_MAXNON - WARM -   72.0000
ACT_MINLD  -  0.5500
ACT_SDTIME - COLD - LO - 20.0000
ACT_SDTIME - COLD - UP - 20.0000
ACT_SDTIME - HOT - LO - 4.0000
ACT_SDTIME - HOT - UP - 4.0000
ACT_SDTIME - WARM - LO - 8.0000
ACT_SDTIME - WARM - UP - 8.0000
ACT_UPS - ANNUAL LO - 0.0500
ACT_UPS - ANNUAL UP - 0.0500
FLO_EMIS -CO2  -  90.6000
NCAP_AFA - LO - 0.5500
NCAP_AFA - UP - 0.8000
BCAP_BND- FX- 0
NCAP_COST  - 1,028.4877
NCAP_FOM  -  25.7122
NCAP_TLIFE -  40
NCAP_PASTI  - 100

My query is :
1) Is using discrete capacity units mandatory for partial load efficiency 
2) as model is free to chose the online capacity at season level, how I can see how much capacity is online at any given timeslice as i am trying to validate my efficiency and fuel consumption assumption
3) How to check how much capacity is shut down by the model and what type of startup the capacity is using (cold, hot, warm)
4) Also suggest if I am missing some parameters to correctly model the partial load efficiency in a plant.

Warm Regards
Vinay Saini
Reply


Messages In This Thread
Modelling Partial Load Efficiency - by vsaini - 29-12-2016, 04:14 PM
RE: Modelling Partial Load Efficiency - by vsaini - 30-12-2016, 05:28 PM
RE: Modelling Partial Load Efficiency - by vsaini - 05-01-2017, 05:31 PM
RE: Modelling Partial Load Efficiency - by vsaini - 17-05-2017, 02:37 PM
RE: Modelling Partial Load Efficiency - by vsaini - 22-05-2017, 10:36 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)